|
|
|
|
|
When a segment is selected, the following information is available in DesignCentral:
|
Path tab |
Point tab |
||||
1. Direction Handle |
2. Selected Point |
|
|
|||
Attributes in a Path tab
Points selected |
Indicates the number of points selected in a path. |
|
Specifies the type of selected segment (straight line or Bezier curve). You can convert one type to another by clicking these buttons. |
|
Specifies the length of the selected segment. In a curved segment, this value is the length of a straight line joining the two ends of the segment (see above illustration). |
|
Specifies the angle of the selected segment. In a curved segment, this value is the angle of a straight line joining the two ends of the segment (see above illustration). |
Attributes in a Point tab
X: Y: |
Displays the X,Y coordinates of the selection point (the point where the segment was clicked). |
|
Displays the length and angle of the Direction Handle marked with a square. |
|
Displays the length and angle of the Direction Handle marked with a circle. |
